Fuses; Bulb Replacement - Can-Am outlander 400 Operator's Manual

Remove corrosion from battery cable
terminals and battery posts using a
firm wire brush. Battery casing should
be cleaned by soft brush and baking
soda solution.
Installation
Reinstall battery in vehicle.
WARNING
Connect RED (+) cable first then
BLACK (-) cable. Always connect
RED (+) cable first.

Fuses

WARNING
Always turn the ignition switch to
OFF position before replacing a de-
fective fuse.
If a fuse is damaged, replace it by one
of the same rating.
CAUTION: Do not use a higher rat-
ed fuse as this can cause severe
damage.
Fuses are located in the front service
compartment and at the rear near bat-
tery.
vmr2007-048-003_a
TYPICAL — FRONT SERVICE
COMPARTMENT
1. Accessories (15 A)
2. Main fuse (20 A)
3. Radiator fan (20 A)
_____________________
120
vmr2007-048-002_d
TYPICAL — REAR FUSE LOCATION
1. Main fuse (30 A)
To remove fuse from holder, remove
the fuse holder cover then pull fuse
out. Check if filament is melted.
TYPICAL
1. Fuse
2. Check if melted

Bulb Replacement

WARNING
Always turn the ignition switch to
OFF position before replacing a de-
fective bulb.
Always check light operation after re-
placement.