Inspecting The Pto Oil Seal; Installing The Pto Oil Seal; Removing The Pto Cover; Inspecting The Pto Cover - Can-Am Renegade 570 2016 Service Manual

Subsection 10 (BOTTOM END)
NOTICE
Avoid scoring surfaces with tool.
vmr2015-034-003_a
1. PTO cover
2. Oil seal

Inspecting the PTO Oil Seal

Check oil seal running surface of crankshaft PTO
side for grooves. Replace if necessary.

Installing the PTO Oil Seal

The installation is the reverse of the removal pro-
cedure however, pay attention to the following de-
tails.
NOTICE
Oil seal must be installed with seal-
ing lip toward the engine.
Push oil seal in place using the following tool.
REQUIRED TOOL
PTO COVER OIL SEAL
INSTALLER (P/N 529 036 033)
vmr2015-034-004_a
1. PTO cover
2. Oil seal installer
3. Oil seal
8
PTO COVER

Removing the PTO Cover

CONTINUOUSLY VARIABLE TRANS-
1. Refer to
MISSION (CVT)
subsection to remove the fol-
lowing parts:
– CVT cover
– Drive pulley
– Driven pulley
– CVT air guide.
2. Disconnect vent hose.
3. Remove PTO cover screws and pull on PTO
cover to remove it.
vmr2006-044-003_a
1. PTO cover
2. PTO cover screws
3. Vent hose nipple

Inspecting the PTO Cover

1. Check the PTO cover for cracks or other dam-
age.
2. Replace PTO cover if damaged.
3. Clean oil breather bore in PTO cover from con-
taminations with a parts cleaner then use pres-
surized air to dry it.
vmr2016-421