Can-Am Renegade 570 2016 Service Manual page 294

PCODE MODULE
P0262 ECM
P0264 ECM
P0265
ECM
P0338 ECM
P0339
ECM
vmr2015
Subsection XX (DIAGNOSTIC AND FAULT CODES)
DESCRIPTION
Damaged injector,
Cylinder 1 injector damaged circuit wires,
shorted to battery damaged connector or
+ damaged ECM output
pins.
Blown fuse, damaged
Cylinder 2 injector or disconnected injector,
open circuit or damaged or disconnected
circuit wires, damaged
shorted to ground
ECM output pins.
Damaged injector,
Cylinder 2 injector damaged circuit wires,
damaged connector or
shorted to battery
+ damaged ECM output
pins.
Damaged CPS,
damaged circuit wires,
Crankshaft
damaged connector or
Position Sensor
damaged ECM output pins.
Spike detected
Wrong mounting position
of sensor
incorect nomber
of tooth detecded
Damaged CPS,
Crankshaft
damaged circuit wires,
Position Sensor
damaged connector or
Intermittent
damaged ECM output pins.
Wrong mounting position
of sensor
CAUSE
Disconnect injector 1
Measure resistance between
injector pin 1 and 2 (Expected
value = 14 to15 ohms).
Measure resistance from
harness connector: INJ1-1 to
INJ1-2 (Expected value: > OPEN)
Measure voltage between harness
connector INJ1-2 and ground.
(Expected value: 11 to 13 volts)
Measure resistance from harness
connector: ECM-K4 to INJ1-1
(Expected value: < 2 ohms)
Disconnect injector 2
Measure resistance between
injector pin 1 and 2 (Expected
value = 14 to15 ohms).
Measure resistance from
harness connector: INJ2-1 to
INJ2-2 (Expected value: > OPEN)
Measure voltage between harness
connector INJ2-2 and ground.
(Expected value: 11 to 13 volts)
Measure resistance from harness
connector: ECM-L4 to INJ2-1
(Expected value: < 2 ohms)
Disconnect injector 2
Measure resistance between
injector pin 1 and 2 (Expected
value = 14 to15 ohms).
Measure resistance from
harness connector: INJ2-1 to
INJ2-2 (Expected value: > OPEN)
Measure voltage between harness
connector INJ2-2 and ground.
(Expected value: 11 to 13 volts)
Measure resistance from harness
connector: ECM-L4 to INJ2-1
(Expected value: < 2 ohms)
Make sure sensor
connector is fully inserted.
Measure resistance from
connector: ECM-E1 to CPS-1
(Expected value: < 2 ohms)
Measure resistance from connector:
ECM-D1 to CPS-2 (Expected value:
< 2 ohms)
Make sure sensor
connector is fully inserted.
Measure resistance from
connector: ECM-E1 to CPS-1
(Expected value: < 2 ohms)
Measure resistance from connector:
ECM-D1 to CPS-2 (Expected value:
< 2 ohms)
ACTION
11