Oil Pressure Regulator Location; Removing The Oil Pressure Regulator; Oil Pump Location; Removing The Oil Pump - Can-Am Renegade 570 2016 Service Manual

Subsection 04 (LUBRICATION SYSTEM)
ENGINE OIL PRESSURE
REGULATOR

Oil Pressure Regulator Location

The oil pressure regulator is located on the engine
magneto side, integrated in the magneto cover.
vmr2016-402-004_a
NOTE: The oil pressure regulator system works
when the oil pressure exceeds 400 kPa (58 PSI).

Removing the Oil Pressure Regulator

Remove plug screw and pull oil pressure regulator
out.
vmr2015-028-003_a
1. Plug screw
2. Gasket ring
3. Pressure regulator housing
4. Spring
5. Pressure regulator valve
Inspecting the Oil Pressure Regulator
Inspect pressure regulator housing and valve for
scoring or other damages.
Check spring for free length.
8
SPRING FREE LENGTH
NEW NOMINAL
SERVICE LIMIT
NOTE: Replace worn or damaged components.
Clean bore and thread in the magneto housing
from metal shavings and other contaminations.
Installing the Oil Pressure Regulator
For installation, reverse the removal procedure.
Pay attention to the following details.
NOTE: At installation always replace the gasket
ring of the plug screw by a NEW one.
OIL PUMP

Oil Pump Location

The oil pump is located on the engine PTO side
(behind PTO cover).
vmr2006-042-009_a
1. Oil pump

Removing the Oil Pump

Remove the PTO cover. Refer to
BOTTOM END
the subsection.
1. Remove:
– Retaining ring
– Oil pump gear
– Needle pin
– Thrust washer.
39 mm (1.535 in)
37 mm (1.457 in)
PTO COVER
in
vmr2016-402