Can-Am Renegade 570 2016 Service Manual page 464

Section 07 CHASSIS
Subsection 03 (DYNAMIC POWER STEERING (DPS))
11
13
vmr2012-039-102_a
DPS AND STEERING TORQUE SEQUENCE (3 OF 3)
12. Install the second hardened steel washer and
nut on each tie-rod end. Tighten retaining nuts
as specified.
TIGHTENING TORQUE
Tie-rod end to pitman arm
13. Install NEW cotter pins on the tie-rod ends.
vmr2010-003-022_b
TYPICAL
1. Hardened steel washers (one each side of pitman arm)
2. Tie rod end retaining nut (torque applied)
3. NEW cotter pin installed
14. Pull bellows down over steering column pinch
bolt and edge of DPS unit housing extension.
Secure bellows using the appropriate locking
tie.
530
72.5 N•m ± 7.5 N•m
(53 lbf•ft ± 6 lbf•ft)
NOTE: Ensure the locking tie is on the tube part of
the steering column, not on the forged end. Bel-
lows should cover end of ring flange on DPS unit
but not cover the drainage hole at the bottom of
the ring flange. Do not install a locking tie on the
DPS end of the bellows. Lower portion of bellows
MUST remain floating over the DPS housing.
vmr2010-003-016_a
TYPICAL
1. Locking tie location
2. Steering column bellows
vmr2010-003-033_a
TYPICAL
1. Drainage hole in DPS ring flange
2. Steering column bellows
15. Turn handlebar fully to each side and check for
proper contact between pitman arm and pit-
man arm frame stops (both sides).
vmr2015-142