vmo2006-007-031_a
TYPICAL — REAR FUSES LOCATION
1. (F8) Main (30 A)
(F9) Main accessories (30 A)
To remove fuse from holder, remove
the fuse holder cover then pull fuse
out. Check if filament is melted.
TYPICAL
1. Fuse
2. Check if melted
Bulb Replacement
WARNING
Always turn the ignition switch to
OFF position before replacing a de-
fective bulb.
Always check light operation after re-
placement.
_____________________
116
Headlamps
CAUTION: Never touch glass por-
tion of an halogen bulb with bare
fingers, it shortens its operating
life. If glass is touched, clean it
with isopropyl alcohol which will
not leave a film on the bulb.
To replace the headlamp bulb, proceed
as follows.
NOTE: The same headlamp is used on
both sides of vehicle and for LO and HI
beams.
Unplug connector from bulb.
vmr2007-050-006_a
Rotate bulb.
vmr2007-050-007_a
Pull out bulb.