Can-Am Renegade 570 2016 Service Manual page 233

IMPORTANT: Do not force to install GBPS if shaft
flat is not properly aligned. If alignment is incor-
rect, check shift rod adjustment.
Tmr2011-016-011_a
1. Flat on shift drum shaft
TIGHTENING TORQUE
GBPS retaining screws
Reset the GBPS. Refer to
subsection.
4WD INDICATOR SWITCH
4WD Indicator Switch Access
To reach the 4WD indicator switch, refer to
and remove the RH engine cover.
Removing the 4WD Indicator Switch
NOTE: Clean area of dirt before removing gear-
box indicator position switch.
Disconnect 4WD indicator switch connector.
vmr2016-422-002_a
Testing the 4WD Indicator Switch
Measure switch resistance as follows.
vmr2016-424
Subsection 13 (GEARBOX AND 4X4 COUPLING UNIT (WITH GBPS))
10 N•m ± 1 N•m
(89 lbf•in ± 9 lbf•in)
GBPS RESET in this
BODY
SWITCH
SWITCH WIRE
POSITION
2WD
BLACK/
BEIGE
4WD
If the resistance is out of specification, replace the
4WD indicator switch.
Installing the 4WD Indicator Switch
For installation, reverse the removal procedure.
Pay attention to the following details.
Take care do not damage indicator switch threads
during installation.
Apply carefully some sealant on threads of indica-
tor switch.
NOTICE
Do not apply sealant on switch
plunger, as it will lead to switch malfunction.
TIGHTENING TORQUE
Service product
Indicator switch
4WD ACTUATOR
4WD Actuator Access
To access the actuator, refer to
the RH engine cover.
vmr2016-422-003
Testing the 4WD Actuator
Check if the 2WD/4WD selector works properly.
RESISTANCE
Close to 0
Engine
ground
Infinite (OL)
LOCTITE 5910 (P/N 293
800 081)
3 N•m ± 0.3 N•m
(27 lbf•in ± 3 lbf•in)
BODY
and remove
9