Installing The 4Wd Indicator Switch; 4Wd Actuator Access; Testing The 4Wd Actuator; Removing The 4Wd Actuator - Can-Am Renegade 570 2016 Service Manual

Subsection 13 (GEARBOX AND 4X4 COUPLING UNIT (WITH EXTERNAL SWITCHES))
SWITCH
SWITCH WIRE
POSITION
2WD
BLACK/
BEIGE
4WD
If the resistance is out of specification, replace the
4WD indicator switch.

Installing the 4WD Indicator Switch

For installation, reverse the removal procedure.
Pay attention to the following details.
Take care do not damage indicator switch threads
during installation.
Apply carefully some sealant on threads of indica-
tor switch.
NOTICE
Do not apply sealant on switch
plunger, as it will lead to switch malfunction.
TIGHTENING TORQUE
Service product
Indicator switch
4WD ACTUATOR

4WD Actuator Access

To access the actuator, refer to
the RH engine cover.
vmr2016-422-003

Testing the 4WD Actuator

Check if the 2WD/4WD selector works properly.
REQUIRED TOOL
FLUKE 115 MULTIMETER
(P/N 529 035 868)
vmr2016-422
RESISTANCE
Close to 0
Engine
ground
Infinite (OL)
LOCTITE 5910 (P/N 293
800 081)
3 N•m ± 0.3 N•m
(27 lbf•in ± 3 lbf•in)
BODY
and remove
Unplug actuator connector.
Turn ignition key ON.
Set emergency engine stop switch to RUN.
Measure voltage as follows.
SWITCH
SWITCH WIRE
POSITION
2WD WHITE/BLUE
4WD WHITE/BLACK
If the selector is out of specifications, check
wires, connectors and replace the selector if nec-
essary.
If the selector is good, check the vehicle harness.
If the vehicle harness is good, replace the actua-
tor.

Removing the 4WD Actuator

NOTE: Clean area of dirt before removing the
4WD actuator.
Make sure the actuator is in 4WD position.
Remove the RH floorboard.
Place a drain pan under actuator.
Remove actuator screws.
Tmr2011-016-025_a
1. Actuator
2. Washer
3. Screw
Pull the actuator out of housing.
Installing the 4WD Actuator
Lubricate actuator O-ring.
VOLTAGE
Battery
WHITE
voltage
9