Water Pump Shaft And Seals Installation - Can-Am Renegade 570 2016 Service Manual

tmr2011-011-011_a
1. Oil seal
2. Machined surface for rotary seal
tmr2011-011-012_a
OIL SEAL REMOVAL - VIEW FROM INSIDE CRANKCASE MAG
SIDE
1. Orifices for oil seal removal

Water Pump Shaft and Seals Installation

The installation is the reverse of the removal pro-
cedure. However, pay attention to the following.
Use tightening torque values specified in the ex-
ploded view.
NOTE: Never apply oil on the press fit area of the
oil seal and rotary seal.
Clean rotary seal surface of any old sealant.
Install oil seal.
REQUIRED TOOL
OIL SEAL PUSHER
(P/N 529 035 757)
HANDLE
(P/N 420 877 650)
When installing the oil seal on the pusher, make
sure the sealing lip points outwards.
vmr2016-417
Push NEW oil seal in place.
tmr2011-011-014_a
1. Oil seal
2. Installer handle with oil seal pusher
Lubricate sealing lip of the oil seal.
SERVICE PRODUCT
Sealing lip of the oil seal
tmr2011-011-011_b
1. Sealing lip
2. Oil seal properly installed
Apply engine oil on the water pump shaft and in-
termediate shaft.
Slide NEW water pump shaft assembly into
crankcase.
REQUIRED TOOL
SEAL PUSHER
(P/N 529 035 766)
DOW CORNING 111
(P/N 413 707 000)
17