Removing The Gearbox Position Indicator Switch; Installing The Gearbox Position Indicator Switch; 4Wd Indicator Switch Access; Removing The 4Wd Indicator Switch - Can-Am Renegade 570 2016 Service Manual

Subsection 13 (GEARBOX AND 4X4 COUPLING UNIT (WITH EXTERNAL SWITCHES))
A blank space indicates switch is not making con-
tact, there should be no continuity (R = infinite).
If the indicator switch is good, check the vehicle
harness and/or indicator lights.
Removing the Gearbox Position
Indicator Switch
NOTE: Clean area of dirt before removing gear-
box indicator position switch(es). Take note of cor-
responding switch position and wire color.
Disconnect indicator switch from engine wiring
harness.
vmr2012-019-004_a
1. Gearbox position indicator switches
2. BROWN/GREY wire
3. WHITE/RED wire
4. ORANGE/GREY wire
Unscrew switch.
Installing the Gearbox Position
Indicator Switch
Reverse the removal procedure. However, pay at-
tention to the following.
Take care to avoid damaging threads in switch
bores during installation.
Carefully apply some sealant on threads of shift
indicator switches.
NOTICE
Do not apply sealant on switch
plunger as it will lead to switch malfunction.
TIGHTENING TORQUE
Service product
Indicator switches
8
LOCTITE 5910 (P/N 293
800 081)
2.5 N•m ± 0.3 N•m
(22 lbf•in ± 3 lbf•in)
If all switches are removed, make sure to put the
wires back in the correct location as noted prior to
removal.
vmr2012-019-004_a
1. Indicator switches
2. BROWN/GREY wire
3. WHITE/RED wire
4. ORANGE/GREY wire
4WD INDICATOR SWITCH

4WD Indicator Switch Access

To reach the 4WD indicator switch, refer to
and remove the RH engine cover.

Removing the 4WD Indicator Switch

NOTE: Clean area of dirt before removing gear-
box indicator position switch.
Disconnect 4WD indicator switch connector.
vmr2016-422-002_a
Testing the 4WD Indicator Switch
Measure switch resistance as follows.
BODY
vmr2016-422