Can-Am Renegade 570 2016 Service Manual page 292

PCODE MODULE
P0118 ECM
P011A
ECM
P0122 ECM
P0123 ECM
P0217 ECM
P0219 ECM
vmr2015
Subsection XX (DIAGNOSTIC AND FAULT CODES)
DESCRIPTION
Engine Coolant
Temperature Disconnected sensor, or
Sensor 1 circuit sensor resistance too High.
High
Engine Coolant
Temperature
Correlation Check failed
Correlation Check
failed
Throttle Position
Damaged circuit wires,
Sensor (TPS)
damaged sensor or
Short circuit to
damaged ECM pins.
GND
Throttle Position
Damaged circuit wires,
Sensor (TPS)
damaged sensor or
shorted to battery
damaged ECM pins.
+
Engine Coolant
Coolant fluid temperature
over temperature
too high
condition
Engine
Overspeed
Engine speed too high
Condition
detected
CAUSE
Disconnect the sensor.
Measure resistance from
connector: ECM-F4 to CTS-1
(Expected value: < 2 ohms)
Measure resistance from
connector: ECM-C3 to CTS-2
(Expected value: < 2 ohms)
Measure CTS resistance value
(Expected value: 2280 to 2736 ohms
at 19 to 21°C (66 to 70°F))
Check for coolant fluid
leak and coolant fluid level
Check radiator condition
Check for other fault, Check
thermostat
Make sure sensor
connector is fully inserted.
Measure resistance from
connector: ECM-A1 to TPS-1
(Expected value: < 2 ohms)
Measure resistance from
connector: ECM-G3 to TPS-3
(Expected value: < 2 ohms)
Measure resistance from connector:
ECM-G2 to TPS-2 (Expected value:
< 2 ohms)
Make sure sensor
connector is fully inserted.
Measure resistance from
connector: ECM-A1 to TPS-1
(Expected value: < 2 ohms)
Measure resistance from
connector: ECM-G3 to TPS-3
(Expected value: < 2 ohms)
Measure resistance from connector:
ECM-G2 to TPS-2 (Expected value:
< 2 ohms)
Check for coolant fluid
leak and coolant fluid level
Check radiator condition
Check for other fault, Check
thermostat
ACTION
9