Installing The Crankshaft - Can-Am Renegade 570 2016 Service Manual

Subsection 10 (BOTTOM END)
vmr2006-044-043_a
1. Angle torque wrench
570 and 850 Engines
NEW connecting rods can be installed either way.
TIGHTENING TORQUE
Step A
Connecting rod Step B
screws
Step C
1000R Engine
NOTICE
Connecting rods are asymmetrical.
There must be no gap between the small ends
when they face each other.
22
Tighten to 1/2 of
specified torque
Tighten to
20 N•m ± 2 N•m
(15 lbf•ft ± 1 lbf•ft)
Torque an additional
60 ± 5° turn using an
angle torque wrench
tmr2011-014-036_a
1. Connecting rod small ends
2. Connecting rod offset
3. Connecting rod screws
TIGHTENING TORQUE
Step A
Connecting rod Step B
screws
Step C

Installing the Crankshaft

For installation of crankshaft in crankcase reverse
the removal procedure. However, pay attention to
the following details.
Do not interchange the connecting rods of pistons
1 and 2 during installation.
NOTICE
Observe the correct installation po-
sition when fitting the crankshaft with the
connecting rods. The connecting rod MAG
side has to face cylinder no. 1.
Tighten to 1/2 of
specified torque
Tighten to
30 N•m ± 2 N•m
(22 lbf•ft ± 1 lbf•ft)
Torque an additional
90 ± 5° turn using an
angle torque wrench
vmr2016-421