Trailing Arm Disassembly; Trailing Arm Pivot Bearing Removal - Can-Am Renegade 570 2016 Service Manual

vmr2015-057-008
6. Firmly hold trailing arm then remove:
– Shock absorber lower screw
– Trailing arm pivot shaft (pull from opposite
side).
NOTE: If only one trailing arm is removed, pull
pivot shaft just enough to clear trailing arm.
vmr2015-057-010
7. Remove trailing arm from vehicle.

Trailing Arm Disassembly

Drive Shaft Bearing Removal
1. Remove circlip securing bearing into trailing
arm.
vmr2015-057-012
2. Install trailing arm on a press.
3. Use an appropriate bearing remover.
vmr2015-057
Section 08 CHASSIS
Subsection 05 (REAR SUSPENSION)
4. Remove drive shaft bearing from trailing arm.
Link Arm Inner Bushing Removal
Remove both bushings and sleeve from trailing
arm.
vmr2015-057-011_a
1. Bushings
2. Sleeve

Trailing Arm Pivot Bearing Removal

1. Remove both spacers and seals from trailing
arm pivot.
vmr2015-057-014_a
1. Spacer
2. Seal
2. Remove bearing with an appropriate bearing re-
mover.
NOTE: Remove one bearing at a time.
3. Remove inner spacer from trailing arm.
vmr2015-057-015_a
1. Pivot bearings
2. Inner spacer
683