Table of Contents
Advertisement
Multifunction Gauge Wire
Identification
FUNCTION
12 volt input from fuse F4
12 volt input from
fuse F10 (Clock)
Ground
CAN LO
CAN HI
Fuel level gauge supply
Fuel level gauge ground
2WD/4WD switch
signal (-)
HI beam signal (+)
Vehicle speed sensor
signal (VSS)
Multifunction Gauge Circuit Protection
CONDITION
Supplied at all times
Supplied with main relay
activated
Setting the Clock with Gauge Selector
Button
To set current time, proceed as follows:
1. Select the clock display.
vmo2011-008-001_a
1. Selector button
2. Time
2. Press and HOLD selector button.
NOTE: The display will flash.
3. Choose the 12-hour (12H) or 24-hour (24H) for-
mat by pressing button.
vmr2016-410
Subsection 07 (LIGHTS, GAUGE AND ACCESSORIES)
PIN
COLOR
17 ORANGE/YELLOW
16
RED/WHITE
20
BLACK
18
WHITE/BLACK
19
WHITE/BEIGE
4
BROWN/PINK
21
VIOLET/PINK
7
BLACK/BEIGE
5
BLUE
9
PINK
CIRCUIT PROTECTION
Fuse 10 of fuse block 1
(from fuse 1 of fuse
block 2)
Fuse 4 of fuse block 1
(from main relay R2)
4. If the 12-hour format was selected, choose Am
(A) or Pm (P) by pressing button.
5. Choose hour first digit by pressing button.
6. Choose hour second digit by pressing button.
7. Choose minutes first digit by pressing button.
8. Choose minutes second digit by pressing but-
ton.
9. Press button to enter settings (CLOCK will ap-
pear on display).
NOTE: The gauge will display the current time for
10 seconds then will return to the normal display
mode.
Setting the Multifunction Gauge with
B.U.D.S.
Connect to the applicable B.U.D.S. software. Re-
fer to
COMMUNICATION TOOLS AND B.U.D.S.
subsection.
Language Selection
In B.U.D.S., select the:
– Setting page tab
– Cluster page tab.
Scroll and select the desired display language in
the Cluster Language box.
vmr2016-137-001_a
Units of Display Selection
In B.U.D.S., select the:
– Setting page tab
– Cluster page tab.
Select Imperial or Metric in the Cluster Units
box.
vmr2016-137-001_b
7
Advertisement
Table of Contents
Troubleshooting
