Can-Am Renegade 570 2016 Service Manual page 532

Subsection 01 (WIRING DIAGRAM INFORMATION)
mbg2008-021-118_a
1. Broken wire
2. Splice
6. Strip wire insulation at the end of broken wire.
7. Strip wire insulation below the splice.
mbg2008-021-119_a
1. Broken wire stripped
2. Splice wire stripped
8. Twist wire around stripped wire.
mbg2008-021-120_a
1. Twisted wire
9. Perform a tin solder on twisted wire.
10. Apply electrical tape to cover splice.
NOTE: Make sure tape overlaps on wire insula-
tion, approximately 13 mm (1/2 in) each side.
11. Reinstall wires into protector tube.
NOTE: Always perform a solder on a bigger wire
(lower gage).
4
vmr2016-149