Assembling The Drive Pulley; One-Way Clutch; Friction Washer - Can-Am Renegade 570 2016 Service Manual

Subsection 11 (CONTINUOUSLY VARIABLE TRANSMISSION (CVT)(570/850))
Check for any marks on fixed sheave plate. Re-
place if necessary.
Spring
Measure spring free length and squareness. If
spring is out of specification, replace by a new
one.
CLUTCH SPRING FREE LENGTH
570
SERVICE LIMIT
ENGINE
850
SERVICE LIMIT
ENGINE
CLUTCH SPRING SQUARENESS
ALL
SERVICE LIMIT
ENGINES

One-Way Clutch

Check bearings for excessive play and smooth op-
eration. Replace bearings if necessary.
NOTICE
Be careful not to damage the inside
of one-way clutch during bearing removal.
vmr2015-035-002_a
1. One-way clutch
2. Bearings
Measure length of spring sleeves and check if
edges on top of the spring sleeve are excessively
worn. If out of specification, replace both spring
sleeves at the same time.
SPRING SLEEVE LENGTH
NEW
SERVICE LIMIT
12
85 mm (3.346 in)
95 mm (3.74 in)
4 mm (.157 in)
9.2 mm to 9.4 mm
(.362 in to .37 in)
9.0 mm (.354 in)

Assembling the Drive Pulley

For assembly, reverse the disassembly proce-
dure. Pay attention to following details.
One-Way Clutch
Clean parts.
Lubricate springs, spring sleeves and between
one way clutch bearings using recommended
product.
REQUIRED PRODUCT
ISOFLEX GREASE TOPAS NB 52 (P/N 293 550 021)

Friction Washer

NOTE: Apply recommended grease on both sides
of friction washer.
REQUIRED PRODUCT
ISOFLEX GREASE TOPAS NB 52 (P/N 293 550 021)
NOTE: Friction washer must be assembled with
collar towards one way clutch.
vmr2007-051-003_a
1. Friction washer
2. Collar
3. One way clutch
Sliding Sheave
Install centrifugal levers with their thrust washers.
NOTICE
Centrifugal levers must move easily
after installation.
Governor Cup
Rebuild governor cup with new roller sleeves,
rollers and slider shoes.
NOTICE
Final position of roller sleeves must
be flush with the sleeve bore in the governor
cup arm (no protrusion).
vmr2016-404