Removing Crop Dividers From Storage; Installing Crop Dividers Without Latch Option - MacDon FFT FD75 Assembly Instructions Manual

3.4.6 Removing Crop Dividers from Storage

Crop dividers are shipped attached to inboard side of endsheets. To remove crop dividers, follow these steps:
1. Open endshields. Refer to
2. Support crop divider and remove shipping wire at front
end (A).
3. Remove bolt (B).
4. Remove bolt with washer (C) and retain for installation.
5. Repeat above steps for opposite end.

3.4.7 Installing Crop Dividers without Latch Option

NOTE:
If crop divider latch option was ordered with header, proceed to
page 86. Otherwise, complete the following procedure:
1. If not already open, open endshields. Refer to
Opening Endshield, page
2. Position crop divider as shown by inserting lugs (A) into
holes (B) in endsheet.
214325
ASSEMBLING HEADER AND ADAPTER
3.4.5 Opening Endshield, page
3.4.5
83.
83.
Figure 3.165: Crop Divider Storage
3.4.8 Installing Crop Dividers with Latch Option,
Figure 3.166: Crop Divider Installation
84
Revision A