MacDon FFT FD75 Assembly Instructions Manual page 37

To enable the reel fore-aft and header tilt options, install the
switch and harness as follows:
1. Before attaching any cable ties, route switch
harness (A) from the front of the feeder house to the
power connection point in the cab. Ensure the harness
is long enough to reach the wiring at the selector valve
with the header tilted forward, and that the feeder house
can be fully lowered with adequate slack in the harness.
2. Use the cable ties provided to fasten the switch
harness (A) to the main harness on the left side of the
feeder house and under the cab floor at (B).
IMPORTANT:
To prevent damage to harness, fully lower feeder house
and ensure there is adequate slack before attaching
cable ties (B) to the harness.
3. Route the switch harness (A) at the rear of the feeder
house up to the underside of the cab floor at (B).
4. Use the cable ties provided to fasten the switch
harness (A) to the main harness under cab floor at (B).
214325
ASSEMBLING HEADER AND ADAPTER
27
Figure 3.25: Switch Harness Routing
Figure 3.26: Left Side of Feeder House
Figure 3.27: Harness under Right Side of
Cab Floor
Revision A