Table of Contents
Advertisement
9. Push handle (A) on combine to fully open position.
10. Clean mating surfaces of multicoupler (B) and
receptacle if necessary.
11. Position multicoupler (A) onto combine receptacle, and
pull handle (B) to fully engage multicoupler into
receptacle.
12. Connect reel fore-aft/header tilt selector harness (C) to
combine harness (D).
13. Remove shipping wire from driveline (A) and float
lock lever (B).
214325
ASSEMBLING HEADER AND ADAPTER
33
Figure 3.38: Combine Receptacle
Figure 3.39: Multicoupler
Figure 3.40: Adapter Shipping Configuration
Revision A
Hide quick links:
Advertisement
Table of Contents
