Configuring Reel Fore-Aft, Header Tilt, And Header Type (New Holland Cr Series) - MacDon FFT FD75 Assembly Instructions Manual

NOTE:
It is not necessary to press rocker switch (D) again after
adjusting.
NOTE:
The ideal ground pressure—in most cases—is one
number (on float indicator box) above header
suspended off ground. For example, if float indicator
needle (A) is positioned at 0 with header suspended off
ground, then ideal ground pressure will be achieved
with needle positioned at 1. Operating with heavier
pressures can wear cutterbar wearplate prematurely.

Configuring Reel Fore-Aft, Header Tilt, and Header Type (New Holland CR Series)

This procedure applies only to 2016 New Holland CR models 6.90, 7.90, 8.90, and 9.90.
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to
combine operator's manual for updates.
1. Simultaneously press both UNLOAD (A) and
RESUME (B) buttons on hydro handle.
214325
SETTING UP AUTO HEADER HEIGHT CONTROL
Figure 5.256: Float Indicator Box
Figure 5.257: New Holland Combine Controls
258
Revision A