Chapter 3: Assembling Header And Adapter; Attaching Reel Lift Cylinders - MacDon FFT FD75 Assembly Instructions Manual

3 Assembling Header and Adapter
Perform all procedures in order in which they are listed.

3.1 Attaching Reel Lift Cylinders

1. Remove two top bolts (A) on outboard reel arm
supports. Repeat for opposite side.
2. Position sling (A) around reel tube (B) close to outboard
end of reel, and attach sling to a forklift (or equivalent).
3. Remove shipping wire/banding from reel lift cylinder.
214325
Figure 3.1: Reel Outboard Support Arm
Figure 3.2: Right End Reel Lift
15
Revision A