8. Select LEFT SEN (A). The exact voltage is displayed.
Raise and lower header to see full range of voltage
readings.
9. Adjust voltage limits (refer to
page
142) if sensor voltage is not within low and high
limits, or if range between low and high limits is
insufficient (refer to Table
Setting Header Controls (Case 8010)
The following procedure applies to Case 8010 combines without a shift button on the GSL.
The reel fore/aft controls (A) also control header fore/aft tilt
(if header is equipped with the fore/aft tilt option). The
ground speed lever (GSL) needs to be configured to allow
the Operator to swap between reel fore/aft and header
fore/aft tilt.
214325
SETTING UP AUTO HEADER HEIGHT CONTROL
Adjusting Voltage Limits,
5.1, page
140).
Figure 5.23: Case 8010 Combine Display
Figure 5.24: Case 8010 Combine Display
Figure 5.25: Case Combine Controls
150
Revision A