Table of Contents
Advertisement
7. Install REEL FORE-BACK (if applicable).
8. Set HEIGHT SENSITIVITY to desired value. The
recommended starting point is 180.
9. Install FORE-AFT CONTROL and HDR FORE-AFT
TILT (if applicable).
10. Press HEAD2 at bottom of page.
11. Ensure HEADER TYPE is DRAPER.
NOTE:
If recognition resistor is plugged into header harness,
you will not be able to change this value.
12. Set cutting type to PLATFORM.
13. Set appropriate HEADER WIDTH and
HEADER USAGE.
214325
SETTING UP AUTO HEADER HEIGHT CONTROL
155
Figure 5.36: Case IH Combine Display
Figure 5.37: Case IH Combine Display
Figure 5.38: Case IH Combine Display
Revision A
Hide quick links:
Advertisement
Table of Contents
