Table of Contents
Advertisement
4. Use HEADER HEIGHT SETPOINT control dial (A) as
necessary to fine-tune setpoint position.
Header In-Field Settings
NOTE:
Changes may have been made to combine controls or display since this document was published. Refer to
combine operator's manual for updates.
1. To quickly view header group settings, touch HEADER
icon (A) that is second from bottom on right of Tyton
terminal home page.
2. The display area shows:
•
(B) – The left header height indicator is current
position of header.
•
(C) – The red line on current header height position
indicator (B) shows setpoint cut-off position.
•
(D) – Adjust setpoint cut-off position by touching
HEADER symbol and using scroll wheel on right of
Tyton terminal. As scroll wheel is moved, position of
cut-off will move.
•
(E) – The right indicator is set cut height for AHHC.
Fine-tune cutting height with header height setpoint
control dial on header control cluster. As control is
adjusted, cut height indicator will move.
•
(F) – The header working width.
•
(G) – Header pitch.
3. Touching a field opens on-screen keyboard so that
values can be adjusted. Enter new value and touch
green check mark when complete.
214325
SETTING UP AUTO HEADER HEIGHT CONTROL
Figure 5.113: Header Control Cluster
Figure 5.114: Header Groups
192
Revision A
Hide quick links:
Advertisement
Table of Contents
