New Holland Combines (Cr Series - Model Year 2015 And Later); Engaging Auto Header Height Control (New Holland Cr Series) - MacDon FFT FD75 Assembly Instructions Manual

5.1.15 New Holland Combines (CR Series – Model Year 2015 and Later)
This section applies only to 2015 and later CR models (6.80, 6.90, 7.90, 8.90, 9.90, and 10.90). For other
New Holland combine models, refer to
2014 and Earlier), page

Engaging Auto Header Height Control (New Holland CR Series)

This procedure applies only to 2015 and later CR models (6.80, 6.90, 7.90, 8.90, 9.90, and 10.90).
For best performance of auto header height control (AHHC), perform these procedures with center-link set to D.
When setup and calibration are complete, adjust center-link back to desired header angle.
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to
combine operator's manual for updates.
1. Ensure center-link is set to D.
2. Select TOOLBOX (A) on main page. The TOOLBOX
page displays.
3. Simultaneously press both UNLOAD (A) and
RESUME (B) buttons on hydro handle.
214325
SETTING UP AUTO HEADER HEIGHT CONTROL
5.1.14 New Holland Combines CX/CR Series (CR Series – Model Year
250.
Figure 5.261: New Holland Combine Display
Figure 5.262: New Holland Combine Controls
260
Revision A