Gleaner S9 Series Combines; Setting Up Header (Gleaner S9 Series) - MacDon FFT FD75 Assembly Instructions Manual

SETTING UP AUTO HEADER HEIGHT CONTROL
Alarm conditions:
If an error message is received from fuse panel, an audible alarm sounds. The LCD on electronic instrument panel
(EIP) indicates header system in error as HDR CTRL followed by HGT ERR for height, and HDR CTRL followed by
TILT ERR for tilt. The header height LED flashes yellow two times every second.
The alarm also is noted by buzzer sounding five times every ten seconds.
When an alarm condition occurs, a green LED flashes on and off (green, yellow, or red depending on input). In
addition, a message is displayed on LCD to identify nature of alarm. For example, HYD TEMP, OPEN, SHRT will be
flashed alternately.
Diagnostic fault failures: Refer to Figure 5.82, page 178.
Pressing header height switch (B) for a minimum of five seconds will put EIP in header diagnostic mode. The LCD
(shown on previous page) will display message HDR DIAG when EIP has entered header diagnostic mode.
In this mode, after three seconds, header fault parameter labels are displayed on EIP LCD. All information
displayed is read-only.
The OK (C) and CLEAR (D) buttons allow you to scroll through list of parameters. If there are no active fault codes,
EIP LCD will display NO CODE.
When a parameter is displayed, its label is displayed for three seconds, after which its value is automatically
displayed.
Pressing OK button (C) while value is displayed will advance to next parameter and display its label.
When a parameter label is displayed and OK button (C) is pressed before three seconds, parameter's value will be
displayed.
Pressing AREA (E) will cycle through options. When LEFT is displayed on LCD, press OK button (C), and auto
header height control (AHHC) voltage will be shown on the display.
Press DIST button (F) to cycle back through table.
Press CLEAR button (D) to exit header diagnostics and return to normal mode.
Refer to 5.1.16 Sensor Operation, page 270.

5.1.7 Gleaner S9 Series Combines

This section is for Gleaner S9 Series combines only.

Setting up Header (Gleaner S9 Series)

NOTE:
Changes may have been made to combine controls or display since this document was published. Refer to
combine operator's manual for updates.
179
214325 Revision A