MacDon FFT FD75 Assembly Instructions Manual page 75

14. Connect wires from the MacDon wiring harness (A) to
the CLAAS harness (B) as follows:
a. Remove insulation from red (C) and black (D)
connectors.
b. Attach red wire (C) in MacDon harness to brown
wire in CLAAS white plug (E).
c. Attach black wire (D) in MacDon harness to black
wire in CLAAS white plug (E).
15. Proceed to Step 24, page 67
multicoupler.
If beside-ignition power source:
16. Remove access panel (A) beside ignition to gain access
to rear of cigarette lighter (B). If a white plug with two
wires is available, it can be used to connect the
MacDon wiring harness.
17. Retrieve white plug (A) on cigarette lighter wiring
harness from behind cigarette lighter.
18. Route MacDon wiring harness from previously installed
switch to rear right corner of cab and into panel
opening. If necessary, add an extension or additional
length to the MacDon wiring harness so that there is
sufficient length to connect to the white plug on the
CLAAS harness.
214325
ASSEMBLING HEADER AND ADAPTER
to connect to the combine
65
Figure 3.114: Power Source Connection
Figure 3.115: Panel
Figure 3.116: Switched Power Harness Plug
Revision A