Setting Auto Height (New Holland Cr Series) - MacDon FFT FD75 Assembly Instructions Manual

Setting Auto Height (New Holland CR Series)

This procedure applies only to 2015 and later CR models (6.80, 6.90, 7.90, 8.90, 9.90, and 10.90).
The console has two buttons used for auto height presets.
The toggle switch that was present on previous models is
now configured as shown at right. MacDon headers only
require first two buttons (A) and (B). The third button (C) is
not configured.
To set auto height, follow these steps:
1. Engage separator and header.
2. Select RUN SCREENS (A) on main page.
214325
SETTING UP AUTO HEADER HEIGHT CONTROL
Figure 5.281: New Holland Combine Controls
Figure 5.282: New Holland Combine Display
268
Revision A