These are primary controls to be used to engage and use
auto header height control (AHHC) function.
1. With header running, set Lateral Tilt to MANUAL by
pressing switch (A) upward to MAN position.
2. Engage AHHC by pressing switch (B) upward to
I position.
3. Press AHHC control switch (A) on ground speed
lever (GSL) to engage AHHC. The header positions
itself in current setpoint position.
214325
SETTING UP AUTO HEADER HEIGHT CONTROL
191
Figure 5.110: Gleaner S9
A - Tyton Terminal
B - Hydro Handle/Ground Speed Lever
C - Throttle Lever
D - Header Control Cluster
Figure 5.111: Header Control Cluster
Figure 5.112: AHHC on GSL
Revision A