Table of Contents
Advertisement
12. Connect feed end to one of the auxiliary power supply
points (D) as follows:
a. Connect wire (from the in-line fuse) to switched
power supply (C).
b. Connect other wire to ground (B).
13. Tape unused wire jumpers to harness.
IMPORTANT:
Connecting switch harness to unswitched power supply
or cigarette lighter will supply constant power to header
tilt side of solenoid valve and drain combine battery
during extended shutdown periods.
14. Route plug end (A) of harness through hole (B) in cab
floor, and feed entire length outside cab. Leave some
slack in cab to allow for console adjustment.
15. Replace floor mat.
214325
ASSEMBLING HEADER AND ADAPTER
44
Figure 3.65: Combine Auxiliary Power Supply
Figure 3.66: Plug End of Harness
Revision A
Hide quick links:
Advertisement
Table of Contents
