Table of Contents
Advertisement
4. Raise header and place two 150 mm (6 in.) blocks (A)
under cutterbar, just inboard of wing flex points.
5. Lower header fully, allowing it to flex into full
frown mode.
6. Set fore-aft position to middle position 5 on fore-aft
position indicator decal (A).
7. Lower reel fully.
8. Shut down engine and remove key from ignition.
9. Measure clearance at ends (A) of each reel and at flex
locations (B).
NOTE:
The reel is factory-set to provide more clearance at
center of reel than at ends (frown) to compensate for
reel flexing.
214325
PERFORMING PREDELIVERY CHECKS
99
Figure 4.17: FlexDraper
Figure 4.18: Fore-Aft Position
Figure 4.19: Measurement Locations
A - Clearance Points
® ®
Block Locations
B - Flex Points
Revision A
Hide quick links:
Advertisement
Table of Contents
