Setting Sensitivity Of Auto Header Height Control (John Deere 70 Series) - MacDon FFT FD75 Assembly Instructions Manual

7. Select HEADER in box (A) by scrolling down to box
using scroll knob, and then pressing check mark button
(knob and button are shown in Figure
8. Scroll down to lower right icon that resembles an arrow
in a diamond (B) and press check mark button to
select it.
9. Follow steps listed on combine display to perform the calibration.
NOTE:
If an error code appears on page, sensor is not in correct working range. Refer to
from Combine Cab (John Deere 70 Series), page 210

Setting Sensitivity of Auto Header Height Control (John Deere 70 Series)

NOTE:
Changes may have been made to combine controls or display since this document was published. Refer to
combine operator's manual for updates.
214325
SETTING UP AUTO HEADER HEIGHT CONTROL
5.160, page 215).
215
Figure 5.159: John Deere Combine Display
Figure 5.160: John Deere Combine Control
Console
A - Scroll Knob
to check and adjust range.
B - Check Mark Button
Checking Voltage Range
Revision A