Setting Cutting Height (Claas 500 Series); Setting Preset Cutting Height (Claas 500 Series) - MacDon FFT FD75 Assembly Instructions Manual

Setting Cutting Height (CLAAS 500 Series)

Cutting heights can be programmed into preset cutting height and auto contour systems. Use preset cutting height
system for cutting heights above 150 mm (5.9 in.), and use auto contour system for cutting heights below
150 mm (5.9 in.).

Setting Preset Cutting Height (CLAAS 500 Series)

NOTE:
Changes may have been made to combine controls or display since this document was published. Refer to
combine operator's manual for updates.
1. Start engine.
2. Activate machine enable switch.
3. Engage threshing mechanism.
4. Engage header.
5. Briefly press button (A) in order to activate auto contour
system, or briefly press button (B) in order to activate
preset cutting height system.
NOTE:
Button (A) is used only with auto header height control
(AHHC) function. Button (B) is used only with return to
cut function.
6. Use < key (C) or > key (D) to select CUTTING HEIGHT
page, and press OK key (E).
7. Use – key (A) or + key (B) to set desired cutting height.
An arrow indicates selected cutting height on scale.
214325
SETTING UP AUTO HEADER HEIGHT CONTROL
Figure 5.205: Joystick Buttons
Figure 5.206: CLAAS Combine Controls
234
Revision A