Attaching Header To John Deere Combine - MacDon FFT FD75 Assembly Instructions Manual

13. Connect the switch harness to the auxiliary power
supply (D). Connect the wire with the in-line fuse to the
switched power supply (C) and the second wire to the
ground (B).
IMPORTANT:
Connecting the switch harness to an unswitched power
supply or cigarette lighter will supply constant power to
the header tilt side of the solenoid valve and drain the
combine battery during extended shutdown periods.

Attaching Header to John Deere Combine

DANGER
To avoid bodily injury or death from unexpected start-up of machine, always stop engine and remove key
from ignition before leaving operator's seat for any reason.
1. Push handle (A) on combine multicoupler receptacle
towards feeder house to retract pins (B) at bottom
corners of feeder house. Clean the receptacle.
CAUTION
Never start or move the machine until you are sure all
bystanders have cleared the area.
2. Start engine and slowly drive combine up to header
until feeder house saddle (C) is directly under adapter
top cross member (D).
3. Raise feeder house slightly to lift header, ensuring
feeder house saddle is properly engaged in
adapter frame.
4. Stop engine and remove key from ignition.
214325
ASSEMBLING HEADER AND ADAPTER
49
Figure 3.77: Auxiliary Power Supply
Figure 3.78: Combine and Adapter
Revision A