Table of Contents
Advertisement
1. Remove four bolts (A) and nuts securing bars (B) to
adapter frame, and remove bars.
2. Repeat for opposite set of stripper bars.
3. Proceed to
3.3 Attaching Header to Combine, page
3.2.4 Replacing Feeder Deflectors: New Holland CR Combines
If header is configured for a New Holland CR960, 9070, or 9080 combine, adapter has a factory-installed feeder
deflector kit to improve feeding into feeder house. The kit can be replaced if necessary.
DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going under machine for any reason.
The FD75/CA25 combine completion package for New Holland models includes both a short feeder kit (installed at
factory) and a long feeder kit for narrow feeder house combines. Refer to Table
Table 3.1 CA25 Feeder Kits for CR Model Combines
Combine Model
CR970, 9070, 9080
CR960, 9060, 940, 9040
If required, replace feeder deflectors as follows:
1. Determine position of existing deflector (A) by
measuring gap (X) between deflector's forward edge
and pan. Record this measurement.
214325
ASSEMBLING HEADER AND ADAPTER
26.
Feeder House Size
Wide
Narrow
24
Figure 3.20: Auger Stripper Bar
3.1, page
Short: 200 mm (7-7/8 in.)
Long: 325 mm (12-13/16 in.)
Figure 3.21: Side View of Deflector
24.
Feeder Kit Size
Revision A
Hide quick links:
Advertisement
Table of Contents
