Setting Preset Cutting Height (New Holland Cr/Cx Series) - MacDon FFT FD75 Assembly Instructions Manual

1. Engage threshing and feeder house.
2. Select HEIGHT SENSITIVITY on combine
display screen.
3. Use + or – buttons to change setting to 200.
4. Press ENTER to save new setting.
NOTE:
The sensitivity can be changed from 10 to 250 in steps
of 10. It is factory-set to 100.

Setting Preset Cutting Height (New Holland CR/CX Series)

To set preset cutting height, follow these steps:
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to
combine operator's manual for updates.
1. Engage threshing mechanism and feeder with switches
(A) and (B).
2. Set HEADER MEMORY rocker switch (D) in STUBBLE
HEIGHT/AUTOFLOAT MODE position (A) or (B).
3. Lower header to desired cutting height using HEADER
HEIGHT AND HEADER LATERAL FLOAT rocker
switch (C).
4. Press AUTOMATIC HEADER HEIGHT CONTROL
button (E) for a minimum of two seconds to store height
position. A beep will confirm setting.
NOTE:
It is possible to store two different header height values
by using HEADER MEMORY rocker switch (D) in
STUBBLE HEIGHT/AUTOFLOAT MODE position (A)
or (B).
5. To change one of memorized header height set points
while combine is in use, use HEADER HEIGHT AND
HEADER LATERAL FLOAT rocker switch (C)
(slow up/down) to raise or lower header to desired
value. Press AUTOMATIC HEADER HEIGHT
CONTROL button (E) for a minimum of 2 seconds to
store new height position. A beep will confirm setting.
NOTE:
Do NOT press too hard on AUTOMATIC HEADER
HEIGHT CONTROL button (E), or float mode will be
disengaged.
214325
SETTING UP AUTO HEADER HEIGHT CONTROL
257
Figure 5.254: New Holland Combine Display
Figure 5.255: New Holland Combine Controls
Revision A