Table of Contents
Advertisement
10. Move wing upward with torque wrench (A) until pointer
lower alignment tab (C) lines up with upper edge of top-
link (B). Observe indicator reading (A) on wrench and
record it.
11. Move wing downward with torque wrench (A) until
pointer upper alignment tab (C) lines up with the lower
edge of the top-link (B). Observe indicator reading (A)
on the wrench and record it.
• If the difference between the readings is 0.5 or less,
the wing is balanced and no further adjustment is
required. Follow the steps below to reinstall the
linkage cover.
• If the difference between the readings is more than
0.5, the wing is not balanced. Refer to
Adjusting Wing Balance, page
• If the indicator range is as shown at right, the wing is
too light.
214325
PERFORMING PREDELIVERY CHECKS
4.12.2
115.
113
Figure 4.47: Balance Linkage
Figure 4.48: Balance Linkage
Figure 4.49: Wrench Indicator
Revision A
Hide quick links:
Advertisement
Table of Contents
