Table of Contents
Advertisement
Table 8.1 Model FD75 FlexDraper
(continued)
ü ü Item
Check header float.
IMPORTANT:
Install all options before setting float and wing balance.
Check wing balance.
Check auger flighting to feed pan clearance.
Check knife hold-down adjustment.
Check fitment of endshields.
Check skid shoes are evenly adjusted at a setting
appropriate for first crop.
Check feeder house variable speed is set to minimum.
Grease all bearings and drivelines.
Check entire machine for shipping wires or strapping and
remove.
Run-up procedure
Check hydraulic hose and wiring harness routing for
clearance when raising or lowering header and reel.
Check lights are functional.
Check auto header height is calibrated and
functioning correctly.
Check knife speed.
Post run-up check. Stop engine.
Check knife sections for discoloration caused by
misalignment of components.
Check for hydraulic leaks.
Check that manual storage case contains all of required
manuals.
Date Checked:
214325
PREDELIVERY CHECKLIST
/CA25 Combine Adapter Predelivery Checklist – North America
® ®
Checked by:
296
Reference
4.11 Checking and Adjusting Header Float, page
105
4.12.1 Checking Wing Balance, page 110
4.13 Adjusting Auger to Pan Clearance, page
119
4.7 Checking and Adjusting Knife Hold-Downs,
page 95
4.19 Checking and Adjusting Endshields, page
135
4.16 Checking and Adjusting Skid Shoes, page
125
—
4.18 Lubricating Header, page 128
—
6 Running up Header, page 273
—
—
5.1 Auto Header Height Control (AHHC), page
139
6 Running up Header, page 273
6.1 Performing Post Run-Up Adjustments, page
276
6.1.1 Adjusting Knife and Guards, page 276
—
4.20 Checking Manuals, page 137
Revision A
Hide quick links:
Advertisement
Table of Contents
