MacDon FFT FD75 Assembly Instructions Manual page 221

2. Check that float lock linkage is on down stops
(washer [A] and nut [B] cannot be moved) at both
locations.
NOTE:
If header is not on down stops during next two steps,
voltage may go out of range during operation causing a
malfunction of auto header height control (AHHC)
system.
3. Adjust cable take-up bracket (B) (if necessary) until
pointer (A) on float indicator is on 0.
4. Press HOME PAGE button (A) on main page of
combine display.
214325
SETTING UP AUTO HEADER HEIGHT CONTROL
211
Figure 5.150: Float Lock
Figure 5.151: Float Indicator Box (Most
Common 5 Volt AHHC Sensor
Assembly Shown)
Figure 5.152: John Deere Combine Display
Revision A