Table of Contents
Advertisement
4. Rotate console (A) to access wiring.
5. Remove plug (A) from cab floor under the console.
Push the MacDon wire harness adapter end connector
through the hole, and route most of the harness
through hole.
6. Make a slit on the rubber floor plug (A) from the center
and slide plug over wiring harness.
NOTE:
Maintain slack in the harness to prevent damage
to harness.
214325
ASSEMBLING HEADER AND ADAPTER
54
Figure 3.89: Opened Console
Figure 3.90: Harness Routing
Revision A
Hide quick links:
Advertisement
Table of Contents
