Operating Auto Header Height - MacDon FFT FD75 Assembly Instructions Manual

NOTE:
The numbers depicted on displays in these illustrations
are for reference purposes only; they are not intended
to represent specific settings for your equipment.

Operating Auto Header Height

To operate your auto header height, follow these steps:
IMPORTANT:
For proper performance, deactivate accumulator (A) as
described in combine's operator's manual.
1. Ensure HEADER HEIGHT RESUME and ACTIVE
HEADER CONTROL functions are ON by pressing
buttons on top monitor. Icons will appear on monitor
with same picture that is displayed on buttons. This
indicates that your auto header height, resume, and
active header control are turned ON.
•
ACTIVE HEADER HEIGHT (A) is indicated with an
arrow going up and down in front of it.
•
HEADER HEIGHT RESUME (B) is indicated with a
header diagram with a curved arrow in front of it.
214325
SETTING UP AUTO HEADER HEIGHT CONTROL
201
Figure 5.130: Accumulator Shut-off
Figure 5.131: Active Header Control Display
Revision A