Operating With A Gleaner S9 Series Combine - MacDon FFT FD75 Assembly Instructions Manual

7. When calibration is complete, a message displays, and
summary information (A) is shown. Green check marks
confirm functions have been calibrated (B). Touch
bottom green check mark (C) to save.
NOTE:
On COMBINE MAIN MENU page, there is a
CALIBRATION icon (A) that, when touched, opens a
general CALIBRATION menu where you can directly
choose from a variety of calibrations including header
and reel calibration.

Operating with a Gleaner S9 Series Combine

NOTE:
Changes may have been made to combine controls or display since this document was published. Refer to
combine operator's manual for updates.
214325
SETTING UP AUTO HEADER HEIGHT CONTROL
Figure 5.108: Completed Calibration Page
Figure 5.109: Direct Calibration Menu
190
Revision A