Setting Sensitivity Of Auto Header Height Control (John Deere S And T Series) - MacDon FFT FD75 Assembly Instructions Manual

9. Click button (A) and instructions will appear on screen
to guide you through remaining calibration steps.
NOTE:
If an error code appears during calibration, sensor is out
of voltage range and will require adjustment. Refer to
Adjusting Voltage Limits, page

Setting Sensitivity of Auto Header Height Control (John Deere S and T Series)

NOTE:
Changes may have been made to combine controls or display since this document was published. Refer to
combine operator's manual for updates.
1. Press button (A) twice and current sensitivity setting will
appear on combine display.
214325
SETTING UP AUTO HEADER HEIGHT CONTROL
142.
225
Figure 5.183: John Deere Combine Display
Figure 5.184: John Deere Combine
Command Center
Revision A