2. On HEAD 1 page, change CUTTING TYPE from FLEX
to PLATFORM as shown at (A).
3. On HEAD 2 page, change HEADER SUB TYPE from
DEFAULT to 80/90 as shown at (A).
There are now two different buttons for ON GROUND
presets. The toggle switch that was present on
previous models is now configured as shown at right.
MacDon headers only require first two buttons (A)
and (B). The third button down (C) is not configured.
214325
SETTING UP AUTO HEADER HEIGHT CONTROL
259
Figure 5.258: New Holland Combine Display
Figure 5.259: New Holland Combine Display
Figure 5.260: New Holland Combine Controls
Revision A