Adjusting Manual Header Raise/Lower Rate (John Deere S And T Series) - MacDon FFT FD75 Assembly Instructions Manual

2. Press – or + icon (A) to adjust rates.
NOTE:
The numbers depicted on displays in these illustrations
are for reference purposes only; they are not intended
to represent specific settings for your equipment.

Adjusting Manual Header Raise/Lower Rate (John Deere S and T Series)

NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to
combine operator's manual for updates.
1. Press button (A) and current sensitivity setting will
appear on monitor.
214325
SETTING UP AUTO HEADER HEIGHT CONTROL
Figure 5.185: John Deere Combine Display
Figure 5.186: John Deere Combine
Command Center
226
Revision A