MacDon FFT FD75 Assembly Instructions Manual page 66

9. Connect rocker switch (B) to the switch end (A) of the
MacDon wiring harness (E) as follows:
•
red wire (C) to center terminal
•
white wire (D) to either outer terminal
NOTE:
Some MacDon wiring harnesses have two red wires
instead of one white and one red. In that case, connect
one red wire to the center terminal, and the second red
wire to either outer terminal. It does not matter which
outer terminal is used.
10. Snap the rocker switch (A) into place.
214325
ASSEMBLING HEADER AND ADAPTER
56
Figure 3.93: Switch End of MacDon Wiring
Harness
Figure 3.94: Rocker Switch
Revision A