Table of Contents
Advertisement
3. Adjust cable take-up bracket (B) (if necessary) until
pointer (A) on float indicator is on 0.
Figure 5.141: John Deere Combine Display
4. Press DIAGNOSTIC button (D) on monitor—DIA appears on monitor.
5. Press UP button (A) until EO1 appears on monitor—this is header adjustment.
6. Press ENTER button (C).
7. Press UP (A) or DOWN button (B) until 24 is displayed on top portion of monitor—this is voltage reading for
sensor.
8. Ensure header float is unlocked.
9. Start combine, and fully lower feeder house to ground.
214325
SETTING UP AUTO HEADER HEIGHT CONTROL
205
Figure 5.140: Float Indicator Box (Most
Common 5 Volt AHHC Sensor
Assembly Shown)
Revision A
Hide quick links:
Advertisement
Table of Contents
