Table of Contents
Advertisement
3. Select HEADER (A) from list of calibration options.
4. Follow calibration steps in order in which they appear
on screen. As you proceed through calibration process,
display will automatically update to show next step.
NOTE:
Pressing ESC key during any of steps or letting system
sit idle for more than three minutes will cause
calibration procedure to stop.
NOTE:
Refer to your combine operator's manual for an
explanation of any error codes.
5. When all steps have been completed, CALIBRATION
COMPLETED message is displayed on screen.
NOTE:
If float was set heavier to complete ground calibration
procedure, adjust to recommended operating float after
calibration is complete.
214325
SETTING UP AUTO HEADER HEIGHT CONTROL
267
Figure 5.278: New Holland Combine Display
Figure 5.279: New Holland Combine Display
Figure 5.280: New Holland Combine Display
Revision A
Hide quick links:
Advertisement
Table of Contents
