Table of Contents
Advertisement
8. Select HEADER HEIGHT/TILT (A). The PARAMETER
page opens.
9. Select LEFT HEADER HEIGHT SEN (A), and then
select GRAPH button (B). The exact voltage is
displayed at top of page. Raise and lower header to see
full range of voltage readings.
10. Adjust voltage limits (refer to
page
142) if sensor voltage is not within low and high
limits or if range between low and high limits is
insufficient (refer to Table
214325
SETTING UP AUTO HEADER HEIGHT CONTROL
Adjusting Voltage Limits,
5.1, page
140).
Figure 5.31: Case IH Combine Display
Figure 5.32: Case IH Combine Display
Figure 5.33: Case IH Combine Display
153
Revision A
Hide quick links:
Advertisement
Table of Contents
