Claas Combines; Installing Reel Fore-Aft/Header Tilt Selector Switch And Harness: Claas 500 Series - MacDon FFT FD75 Assembly Instructions Manual

14. Disengage each adapter float lock by moving latch (A)
away from adapter and moving both header float lock
levers (B) down (UNLOCK).
15. Proceed to 3.4 Completing Header Assembly, page

3.3.4 CLAAS Combines

Installing Reel Fore-Aft/Header Tilt Selector Switch and Harness: CLAAS 500 Series

IMPORTANT:
To prevent possible damage to electronic components, disconnect the positive cable from the combine battery and
turn BATTERY DISCONNECT switch OFF before connecting harness to combine connectors.
1. Prepare to install the REEL FORE-AFT/HEADER TILT
switch:
a. Fully lower combine feeder house.
b. Shut down the combine. Disconnect the
battery cable.
c. Obtain the long reel fore-aft/header tilt switch wire
harness (MD #279753) from the completion
package kit.
214325
ASSEMBLING HEADER AND ADAPTER
79.
52
Figure 3.85: Float Lock in UNLOCK Position
Figure 3.86: MD #279753 Wiring Harness
A - Cab End
B - Multicoupler End
C - Power Supply Connectors
D - Switch Connectors
Revision A